FSIQ3产品详情:
技术参数
FSIQ3:20Hz - 3.5GHz
FSIQ7: 20Hz -7GHz
FSIQ26: 20Hz -26GHz
FSIQ40: 20Hz -40GHz
*频谱分析
—用于高难度ACPR测量的较宽动态范围:NF=15dB而TOI = +20 dBm;所以质量因子为NF-NOI=+5dBm
—适用于W-CDMA(4.096MHz积分带宽)测量的75dB ACPR动态范围
—82dB ACPR动态范围(4.096MHz积分带宽)。但需相隔一信道2.2GHz
以下总测量误差<1dB,7GHz以下<1.5dB
—分辨率带宽1Hz - 10MHz,以1/2/3/5 倍步进
—具有高选择性的5较点分辨滤波器
—适于快速测量分辨率带宽(RBW)为1Hz至1kHz的FFT 滤波器
—显示出的背景噪声平均功率为-150dBm/10Hz带宽(典型值)
*矢量信号分析
—仪器内置的矢量信号分析仪用于对数字和模拟调制信号进行一般性
分析,具体支持的调制方式包括BPSK至16QAM/(G)MSK/AM/FM/PM
—用于W-CDMA系统的矢量信号分析仪
—采样速率可达6.4 兆符号/秒
*通用信号分析功能
—高速合成器在FULL SPAN(全跨度)模式下扫描时间仅5ms(FSIQ3/7)
—快速时域分析功能在ZEROSPAN(零跨度)模式下扫描时间仅1ms
—用于对任意波形信号进行高精度可重复测量的真有效值检波器
—高显示刷新率每秒可刷新25次
频谱分析
—用于高难度ACPR测量的较宽动态范围:NF=15dB而TOI = +20 dBm;所以质量**为NF-NOI=+5dBm
—适用于W-**(4.096MHz积分带宽)测量的75dB ACPR动态范围
—82dB ACPR动态范围(4.096MHz积分带宽)。但需相隔一信道2.2GHz
以下总测量误差<1dB,7GHz以下<1.5dB
—分辨率带宽1Hz - 10MHz,以1/2/3/5 倍步进
—具有高选择性的5较点分辨滤波器
—适于快速测量分辨率带宽(RBW)为1Hz至1kHz的FFT 滤波器
—显示出的背景噪声平均功率为-150dBm/10Hz带宽(典型值)
*矢量信号分析
—仪器内置的矢量信号分析仪用于对数字和模拟调制信号进行一般性
分析,具体支持的调制方式包括BPSK至16QAM/(G)MSK/AM/FM/PM
—用于W-**系统的矢量信号分析仪
—采样速率可达6.4 兆符号/秒
*通用信号分析功能
—高速合成器在FULL SPAN(全跨度)模式下扫描时间仅5ms(FSIQ3/7)
—快速时域分析功能在ZEROSPAN(零跨度)模式下扫描时间仅1ms
—用于对任意波形信号进行高精度可重复测量的真有效值检波器
—高显示刷新率每秒可刷新25次
—具有高分辨率的彩色大显示屏(24厘米/9.5英寸TFT)
FSQ26 20Hz至26.5GHz。
FSQ不仅继承了FSU的出色的频谱分析仪特性和功能,而且其解调和分析带宽可高达120MHz,还提供了基站频谱杂散发射和多载波测量所必需的高动态范围。因此,FSQ是进行下列产品开发和生产的理想工具:WLAN、WiMAX、WCDMA、HSPA/HSPA+、GSM/EDGE/GPRS、CDMA2000/1x EV-DO、TD-SCDMA、LTE TDD/LTE FDD、Bluetooth等。
为了解决日益增加的数据吞吐量问题,未来移动无线和相关领域对带宽的要求必然越来越高。即使今天,GSM或3GPP基站的多载波信号在功率输出阶段常常需要进行放大,尽管这样一方面可以降低技术要求和成本,但同时也增加了传输带宽。随着分析带宽要求的提高,现有频谱分析仪产品已经难于满足分析要求,市场需要具有更高分析带宽的产品,而同时满足动态范围的苛刻要求。
R&S?FSQ不仅继承了R&S?FSU的出色的频谱分析仪特性和功能,而且其解调和分析带宽可高达120MHz。因此,R&S?FSQ是进行下列产品开发和生产的理想工具:
?WLAN
?3GPP和 GSM-MCPA
?WiMAX
除此之外,当与下列应用选件一起工作时,R&S? FSQ26还能支持2G、2.5G、3G以及4G移动无线系统的测量应用:
GSM/EDGE Application Firmware
R&S?FS-K5
AM/FM/PM Measurement Demodulator
for R&S?FSQ/FSU/FSP/FSUP Analyzers and the R&S?ESCI/ESPI Test Receivers
R&S?FS-K7
Bluetooth? Application Firmware
R&S?FS-K8
Power Sensor Measurements
R&S?FS-K9
GSM/EDGE/EDGE Evolution Measurements
R&S?FS-K10
VOR/ILS Measurement Demodulator
for R&S?FSMR/R&S?FSU/R&S?FSQ - Analysis for VOR and ILS **s
R&S?FS-K15
Application Firmware for Noise Figure and Gain Measurements for R&S?FSP, R&S?FSU and R&S?FSQ (preamplifier recommended, e.g. R&S?FSU-B25)
Outperforming any conventional noise measurement system
R&S?FS-K30
Application Firmware for phase noise measurements
R&S?FS-K40
Firmware General Purpose Vector Signal Analyzer
Universal demodulation, analysis and documentation of digital radio **s
This option is available for instruments for:
R&S?FSUP8: as of serial number 100024
R&S?FSUP26: as of serial number 100068
R&S?FSUP50: as of serial number 100013
R&S?FSQ-K70
3GPP BTS/Node B FDD Application Firmware
3GPP transmitter measurements with R&S?FSQ ** analyzers and R&S?FSU, R&S?FSG, R&S?FSUP, R&S?FSMR, R&S?FMU and R&S?FSP spectrum analyzers
R&S?FS-K72
3GPP UE FDD Application Firmware (including HSUPA)
3GPP transmitter measurements with R&S?FSQ ** analyzers and R&S?FSU, R&S?FSG, R&S?FSUP, R&S?FSMR, R&S?FMU and R&S?FSP spectrum analyzers
R&S?FS-K73
3GPP HSPA+ UE Application Firmware
3GPP transmitter measurements with R&S?FSQ ** analyzers and R&S?FSU, R&S?FSG and R&S?FSP spectrum analyzers.
Requires R&S?FS-K73
R&S?FS-K73+
3GPP HSDPA Base Transceiver Station (BTS) Application Firmware
3GPP transmitter measurements with R&S?FSQ ** analyzers and R&S?FSU, R&S?FSG, R&S?FSUP, R&S?FSMR, R&S?FMU and R&S?FSP spectrum analyzers.
Requires R&S?FS-K72
R&S?FS-K74
3GPP HSPA+ BTS Application Firmware
3GPP transmitter measurements with R&S?FSQ ** analyzers and R&S?FSU, R&S?FSG, R&S?FSUP, R&S?FSMR, R&S?FMU and R&S?FSP spectrum analyzers.
Requires R&S?FS-K74
R&S?FS-K74+
3GPP TD-SCDMA BTS Application Firmware
Base station and mobile station tests on TD-SCDMA with the R&S?FSQ, R&S?FSU and R&S?FSP
R&S?FS-K76
3GPP TD-SCDMA Mobile Station (MS) Application Firmware
Base station and mobile station tests on TD-SCDMA with the R&S?FSQ, R&S?FSU and R&S?FSP
R&S?FS-K77
CDMA2000? / IS-95 (cdmaOne) / 1xEV-DV BTS Test Application Firmware
R&S?FS-K82
CDMA2000? /1xEV-DV MS Application Firmware
R&S?FS-K83
CDMA2000? 1xEV-DO Base Station Test Application Firmware (including Rev A)
Transmitter measurement on 3GPP2 **s with Signal Analyzer R&S?FSQ and Spectrum Analyzers R&S?FSU and R&S?FSP
R&S?FS-K84
CDMA2000? 1xEV-DO Mobile Station Test Application Firmware
Transmitter measurement on 3GPP2 **s with Signal Analyzer R&S?FSQ and Spectrum Analyzers R&S?FSU and R&S?FSP
R&S?FS-K85
WLAN 802.11a/b/g/j Application Firmware
R&S?FSQ-K90
WLAN Application Firmware
WLAN IEEE 802.11 a/b/g/j TX Application Firmware
R&S?FSQ-K91
WLAN Application Firmware
R&S?FSQ-K91 Upgrade to IEEE 802.11n
R&S?FSQ-K91n
Application Firmware
TX measurements on OFDM **s in line with IEEE 802.16-2004
R&S?FSQ-K92
Application Firmware
R&S?FSQ-K92 to R&S?FSQ-K93 Upgrade
(R&S?FSQ-K92 required)
R&S?FSQ-K92U
Application Firmware
TX measurements on OFDMA **s in line with IEEE 802.16-2004, IEEE 802.16e-2005
R&S?FSQ-K93
Application Firmware
TX measurements on WiMAXTM MIMO **s in line with IEEE 802.16e-2005
R&S?FSQ-K94
Analysis of EUTRA/LTE FDD downlink **s
3GPP LTE transmitter measurements on base stations and modules with the R&S?FSG and R&S?FSQ Signal Analyzer
R&S?FSQ-K100
Analysis of EUTRA/LTE FDD uplink **s
3GPP LTE transmitter measurements on user equipment and modules with the R&S?FSG and R&S?FSQ Signal Analyzer
R&S?FSQ-K101
Analysis of EUTRA/LTE downlink MIMO **s
3GPP LTE transmitter measurements on base stations and modules with the R&S?FSG and R&S?FSQ Signal Analyzer
(requires R&S?FSQ-K100)
R&S?FSQ-K102
Analysis of EUTRA/LTE TDD downlink **s
Transmitter measurements on LTE **s
R&S?FSQ-K104
Analysis of EUTRA/LTE TDD uplink **s
Transmitter measurements on LTE **s
R&S?FSQ-K105
TETRA Release 2 Analysis
TETRA/TEDS measurements for the R&S?FSU / R&S?FSQ
R&S?FS-K110